CE is a passport to the European market, the “CE” mark is a compulsory certification mark in the EU market. No matter domestic or foreign products, they must be affixed with the “CE” mark as long as they circulate in the EU market.
EN388:Gloves giving protection from mechanical risks.
Protection against mechanical hazards is expressed by a pictogram followed by four numbers (performance levels), each representing test performance against a specific hazard.
EN388:2016 sample graph:
Sample code | Performance Level | Test for |
4 | 1-4 | Abrasion resistance |
5 | 1-5 | Blade cut resistance |
4 | 1-4 | Tear resistance |
3 | 1-4 | Puncture resistance |
D | A to F | Cut resistant method(EN ISO 13997) |
P | P, F, X | Impact Protection |
“X” indicates that the gloves has not been submitted to the test or the test method appears not to be suitable for the glove design or material.
1 Resistance to abrasion
Based on the number of cycles required to abrade through the sample glove (abrasion by sandpaper under a stipulated pressure). The protection factor is then indicated on a scale from 1 to 4 depending on how many revolutions are required to make a hole in the material. The higher the number, the better the glove. See table below.
2 Blade cut resistance
Based on the number of cycles required to cut through the sample at a constant speed. The protection factor is then indicated on a scale from 1 to 4.
3 Tear resistance
Based on the amount of force required to tear the sample.
The protection factor is then indicated on a scale from 1 to 4.
4 Puncture resistance
Based on the amount of force required to pierce the sample with a standard sized point. The protection factor is then indicated on a scale from 1 to 4.
Volume Resistivity
This indicates Volume resistivity, where a glove can reduce the risk of electrostatic discharge. (Pass or fail test). These pictograms only appear when the gloves have passed the relevant test.
If some of the results are markt with a X means that this test performance is not tested. If some of the results are markt with a O means that the glove did not pass the test.
